How to setup windows xp in usb

Proceed with the installation. The setup program will then silently close, which might make you think that something went wrong. Don't worry though.

Note: The above guide works with Windows XP only. Buy Now. Contact US. Insert the USB drive you intend to boot from. Instructions for doing so vary wildly from system to system, but generally entail the following: Reboot the system. Go to the section that contains your boot devices.

Exit from the BIOS configuration, saving all changes. Step 4: Prepping the Hard Disk You need to make sure that your hard drive is partitioned and formatted properly. To repartition and format This procedure will destroy any data on the hard drive : Click the icon on task bar to launch a command line Window.

Enter DiskPart to run the built-in disk management utility. For example, try the following: select disk 0 select the first disk. Unplug USB drive during post stage. Change your BIOS settings back to boot from hard disk again as needed. You can now continue to finish setting up Windows XP.

Copyright Power Software Ltd. Assuming that it is supported as is the case with virtually all modern hardware , promote your USB drive to the primary boot device. Be aware though, that you can seriously screw up your system by providing incorrect settings! Depending on the speed of your USB drive, this may take a while. Is the USB device listed and does it have top priority? Have you correctly prepared the USB drive in step one?

Restart the procedure. Does your USB drive properly support being booted from? Try another one! You need to make sure that your hard drive is partitioned and formatted properly. Especially if you've had Linux or some other operating system on it, you'll need to repartition and format it. If you are sure that your hard drive is set up properly i. To repartition This procedure will destroy any data on the hard drive :. Enter the commands needed to repartition your drive. For example, try the following: select disk 0 select the first disk , clean purges the entire drive, essentially resetting it , create partition primary creates a single partition from the entire disk , assign assign the partition a drive letter , exit quits DiskPart.

To format This procedure will destroy any data on the hard drive :. Right-click on the target drive e. It requires a functional Windows system. Start AnyBurn v3. Click the button, "Create bootable USB drive", a dialog will popup. If you are using Windows Vista or higher operating system, you need confirm the UAC dialog to continue.

If multiple USB drives are connected to the computer, please make sure that you have choosen the correct drive. Please note that you'll only need the i folder. Instructions for doing so wildly from system to system, but generally entail the following:. Hotkey instructions are generally provided on the screen. Assuming that it is supported as is the case with virtually all modern hardware , promote your USB drive to the primary boot device. Be aware though, that you can seriously screw up your system by providing incorrect settings!

Depending on the speed of your USB drive, this may take a while. Is the USB device listed and does it have top priority? Have you correctly prepared the USB drive in step one? Restart the procedure. You need to make sure that your hard drive is partitioned and formatted properly.